All Issue

2022 Vol.15, Issue 4 Preview Page
A Study on the Application of Non-destructive (Ultrasonic) Inspection Technique to Detect Defects of Anchor Bolts for Road Facilities

도로시설물 적용 앵커볼트 결함 검출을 위한 비파괴(Ultrasonic) 검사 기법 적용에 대한 연구

Dong-Woo Seo1
,
Jaehwan Kim1
,
Jin-Hyuk Lee2
,
Han-Min Cho2
,
Sangki Park1*
,
Min-Soo Kim3
서 동우1
,
김 재환1
,
이 진혁2
,
조 한민2
,
박 상기1*
,
김 민수3
1Senior Researcher, Korea Institute of Civil Engineering and Building Technology
2Post-doctorate Researcher, Korea Institute of Civil Engineering and Building Technology
3CEO, MSNE Ltd.
1한국건설기술연구원 구조연구본부 수석연구원
2한국건설기술연구원 구조연구본부 박사후연구원
3(주)엠에스엔이 대표이사
*Corresponding Author
31 December 2022. pp. 11-20
PDF XML Citation
Abstract

The general non-destructive inspection method for anchor bolts in Korea applies visual inspection and hammering inspection, but it is difficult to check corrosion or fatigue cracks of anchor bolts in the part included in the foundation or in the part where the nut and base plate are installed. In reality, objective investigation is difficult because inspection is affected by the surrounding environment and individual differences, so it is necessary to develop non-destructive inspection technology that can quantitatively estimate these defects. Inspection of the anchor bolts of domestic road facilities is carried out by visual inspection, and since the importance of anchor bolts such as bridge bearings and fall prevention facilities is high, the life span of bridges is extended through preventive maintenance by developing non-destructive testing technology along with existing inspection methods. Through the development of this technology, non-destructive testing of anchor bolts is performed and as a technology capable of preemptive/active maintenance of anchor bolts for road facilities, practical use is urgently needed. In this paper, the possibility of detecting defects in anchor bolts such as corrosion and cracks and reliability were experimentally verified by applying the ultrasonic test among non-destructive inspection techniques. When the technology development is completed, it is expected that it will be possible to realize preemptive/active maintenance of anchor bolts by securing source technology for improving inspection reliability.

Keywords
Road facility
Anchor bolt
Damage detection
Non-destructive test
Field application

국내의 앵커볼트 일반 비파괴 검사법은 육안검사와 타음검사를 적용하고 있으나, 육안검사는 기초에 포함된 부분이나 너트 및 베이스플레이트가 설치된 부분에서 앵커볼트의 부식이나 피로균열 등을 확인하는 것이 어렵다. 타음검사는 주변 환경과 개인차에 의한 영향을 받기 때문에 객관적인 조사가 어려운 것이 현실이므로 이러한 결함을 정량적으로 추정할 수 있는 비파괴 검사 기술개발이 필요하다. 국내 도로시설물 앵커볼트의 점검은 육안조사를 수행하고 있으며, 교량받침, 낙교방지시설 등의 앵커볼트 중요도가 높으므로 기존 점검방법과 함께 비파괴검사 기술을 개발하여 앵커볼트의 예방정비를 통해 교량 수명연장에 기여할 필요가 있다. 본 기술 개발을 통해 현재 수행하고 있지 않은 앵커볼트의 비파괴검사를 수행함으로 도로시설물 앵커볼트의 선제적/능동적 유지관리가 가능한 기술로 연구개발 및 실용화가 시급하다. 본 논문에서는 비파괴 검사 기법 중 초음파탐상법(Ultrasonic test)을 적용하여 부식, 균열 등 앵커볼트의 결함 검출 가능성 및 실뢰도를 실험적으로 검증하였다. 기술 개발이 완성되면 검사 신뢰성 향상 원천기술 확보로 앵커볼트에 대한 선제적/능동적 유지관리의 실현이 가능할 것으로 기대된다.

키워드
도로시설물
앵커볼트
결함 검출
비파괴 검사
현장 적용
References
1
AASHTO (2010). AASHTO Bridge Element Inspection Guide Manual. American Association of State Highway and Transportation Officials (AASHTO). Washington, DC, USA: American Association of State Highway and Transportation Officials (AASHTO).
2
Ann, H. K., Kim, H. M., Jhang, K. Y., Park, I. K., Kwang, N. G., and Lee, C. M. (2005). Detection of Laser Excited Lamb-Wave using Air-Coupled Transducer and Wave Mode Identification using Wavelet Transform. Review of Progress in Quantitative Nondestructive Evaluation. American Institute of Physics. 24: 1018-1025. 10.1063/1.1916784
3
Ditri, J. J., Rose, J. L., and Chen, G. (1992). Mode selection criteria for defect detection optimization using Lamb waves. Review of Progress in Quantitative Nondestructive Evaluation. Edited by D. O. Thompon and D. E. Chimenti. Plenum press, New York. Vol. 11, pp. 2109-2115.
4
FHWA (2004). Guidelines for Ultrasonic Inspection of Hanger Pins. Federal Highway Administration, Publication NO. FHWA-HRT-04-042. Washington, DC, USA: Federal Highway Administration (FHWA).
5
Gazis, D. C. (1959). Three-dimensional Investigation of the Propagation of Waves in Hollow Circular Cylinders, I. Analytical Foundation. J. Acoust. Soc. Am. 31(5): 568-573. 10.1121/1.1907753
6
Graff, K. F. (1995). Wave Motion in Elastic Solids. Dover Publication Inc., New York.
7
Jun, G.-H., Shin, J.-Y., and Jang, J.-T. (2003). A Study on the Evaluation Criteria for Bridge Bearings-P2. Korea Infrastructure Safety Corporation. TS-03-R3-011.
8
Kim, H.-M. (2008). Development of Non-Contact Single Mode Ultrasonic Guided Wave Technology and its Application to Non-Destructive Evaluation. Ph. D. Dissertation, Hanyang University.
9
MOLIT (2022a). Road Bridge and Tunnel Status Report, Ministry of Land, Infrastructure and Transport. Sejong: MOLIT.
10
MOLIT (2022b). Budget Status of Land, Infrastructure and Transport Report, Ministry of Land, Infrastructure and Transport. Sejong: MOLIT.
11
No, Y. J. and Lee, S. J. (2014). Road Structure Expansion Joint Technology Overview. Korean Society of Road Engineers. 16(3): 17-20.
12
Park, C.-h., Shin, J., and Ku, B. (2005). A Study for Preventive Maintenance of Bridge. Korea Expressway Corporation Highway Research Center. 2005 Annual Report, RT-ST-05-09. Hwaseong-si : Korea Expressway Corporation Research Institute.
13
Park, I.-K., Kim, H.-M., Kim, Y.-K., and Cho, Y.-S. (2006). Ultrasonic Guided-Wave Mode Identification in Pipe by Using Air-coupled Transducer and Time-Frequency Analysis. Key Engineering Materials. 321-323: 804-807. 10.4028/www.scientific.net/KEM.321-323.804
14
Park, K. S. (2014). Bridge Maintenance Manual. Korea Infrastructure Safety Corporation. 2014.12.
15
Rose, J. L. (1999). Ultrasonic in Solid Media. Cambridge University Press. 1999.
16
The Korea Economic Daily (2020). https://www.hankyung.com/society/article/202001065015Y. accessed 1 December 2022.
17
Yonhap News (2018). https://www.yna.co.kr/view/AKR20180918056600051. accessed 1 December 2022.

Korean References Translated from the English

1
국토교통부 (2022a). 도로 교량 및 터널 현황 조서. 세종: 국토교통부.
2
국토교통부 (2022b). 국토교통 예산현황(https://www.molit.go.kr/USR/budget/m_90/lst.jsp). 세종: 국토교통부.
3
김현묵 (2008). 비접촉식 단일모드 유도초음파 기술의 개발과 비파괴평가에의 응용. 한양대학교 박사학위논문.
4
노영진, 이석준 (2014). 도로 구조물 신축이음장치 기술 개요. 한국도로학회. 16(3): 17-20.
5
박광순 (2014). 교량 유지관리매뉴얼. 한국시설안전공단. 2014.12.
6
박창호, 신재인, 구본성, 서상길(2005). 교량 예방적 유지관리방안 연구. 한국도로공사 도로교통기술원. 2005년도 연구보고서. 도로교통 ST-05-09.
7
전귀현, 신주열, 장종탁 (2003). 교량받침의 평가기준에 관한 연구(II). 한국시설안전기술공단. TS-03-R3-011.
8
연합뉴스 (2018). https://www.yna.co.kr/view/AKR20180918056600051. accessed 1 December 2022.
9
한경닷컴 (2020). https://www.hankyung.com/society/article/202001065015Y. accessed 1 December 2022.
Information
  • Publisher :Korean Society of Disaster and Security
  • Publisher(Ko) :한국방재안전학회
  • Journal Title :Journal of Korean Society of Disaster and Security
  • Journal Title(Ko) :한국방재안전학회 논문집
  • Volume : 15
  • No :4
  • Pages :11-20
  • Received Date : 2022-11-24
  • Accepted Date : 2022-12-01
  • DOI :https://doi.org/10.21729/ksds.2022.15.4.11
Journal Informaiton Journal of Korean Society of Disaster and Security Journal of Korean Society of Disaster and Security
Online submission
  • KISTI Current Status
  • KISTI Cited-by
  • KCI 문헌 유사도 검사
  • orcid
  • open access
  • ccl
Journal Informaiton Journal Informaiton - close